Door and window lock installation Hobart

Yes, we can, and you’re not imagining it. When Hobart turns cold and damp, the timber around your lock swells just enough to throw the latch out of line. Add a bit of salt air and the brass starts to pit, which makes the key feel tight or gritty.

We don’t just oil and hope for the best. We realign the latch, clean the cylinder pins, and polish the keyway with graphite so it runs smoothly again. A service like that once a year keeps everything turning cleanly and can double the life of your lock.

Absolutely. Old joinery is a joy when it’s looked after, but it can split in a heartbeat if you don’t know how to handle it. We use low-profile hardware and drill by hand instead of power tools, so we don’t stress the grain.

We’ll fit snug security locks for windows and doors that hold tight but blend into the existing timber. We often match brass finishes or even age new fittings to blend with older ones. You’ll keep the character of your home and gain proper security without a scratch.

We do, and it’s something every family with upstairs rooms should think about. These locks limit how far a sash can open while still allowing ventilation, and most can be disengaged easily for cleaning or emergency exits.

When we install child-safety locks, we also check the balance cords and hinges on older windows. If they’re worn or loose, we’ll tighten or replace them so the window can’t slip shut unexpectedly. It’s a small check that prevents big accidents.

That’s a good question, and one that catches plenty of homeowners out. Many older houses still rely on spring-latch locks that can be slipped open in seconds. Most insurers prefer deadlocks or double-cylinder locks that physically bolt the door in place.

We can inspect your current setup, measure the throw of the bolt, and recommend proper lock installation and replacement options that meet Australian Standard AS4145.2. We’ll even check the strike plate and screws because a strong lock means nothing if it’s fastened into soft timber. Most insurance-grade inspections take under an hour.

Yes, and it’s one of the neatest upgrades you can make. We rekey locks so one key opens everything, including the front door, back door, windows, and even the shed if you’d like. It’s cleaner, safer, and you’ll stop carrying a pocket full of mismatched metal.

We use precision equipment for key cutting and duplication on-site, test each key in every cylinder, and label everything before we leave. That way, if you ever need extras later, we’ve got your system saved.

If the handle moves or the latch feels wobbly, it’s already wearing down. Hobart’s salt air works like fine sandpaper. It creeps into the mechanism and grinds away at the moving parts until they give up entirely.

We strip, clean, and re-seat the mechanism, and if it’s beyond repair, we fit a new mortice lock designed for sliding frames. We also swap out short screws for longer ones that bite deeper into the frame, so the strike plate stays firm. The right lock, aligned properly, will hold up through years of humidity and family traffic without giving you grief.

Yes, and we take a lot of pride in doing it well. We often fit modern locks into heritage frames using the same screw holes or hinge lines, so the new fittings look like they’ve always been there.

We can even integrate discreet keyless digital locks for doors or side entries if you’d like to modernise without losing your home’s charm. The trick is in the finishing, with smooth edges, flush fittings, and no visible scars from the old gear.

We do. Most days we’ve got at least one van running through the south, including Kingston, Blackmans Bay, Taroona, and Sandy Bay, so chances are we’re already nearby.

We carry a wide range of parts and replacement barrels in the van, which means most jobs are sorted on the first visit. If you call before lunch, we can almost always get to you the same day. Quick, neat, and no drama, just how we like it.